By Sonali Paul
MELBOURNE, Feb 6 (Reuters) - A valve failure that caused
a flame to flare up briefly on the world's first liquid hydrogen
carrier before its first trip from Australia to Japan
highlighted the need for strong fault detection systems, an
Australian safety report found.
The cause of the incident on the Suiso Frontier on Jan. 25
last year has been fixed, the Australian Transportation Safety
Board said in a report released last week. The ship had loaded
liquid hydrogen for the trip the day before.
The ship's builder, Kawasaki Heavy Industries (KHI)
7012.T , was not immediately available to comment on the
report.
The malfunction did not stop the ship going ahead with its
test journey, and KHI said in March the trip had shown that
shipping liquid hydrogen was technically feasible.
Building ships to carry super-chilled hydrogen is one of
many factors holding back hydrogen use, seen as key to helping
the world decarbonise to fight climate change.
The malfunction on the Suiso Frontier was because of an
automated valve in its gas combustion unit being damaged during
the ship's journey from Japan to Australia as it had the wrong
specification for the control system's power supply, the safety
bureau said in its report released on Feb. 2.
The unit burns off the small amount of hydrogen gas that
evaporates from the super-cooled liquid during transit to
control the pressure inside storage tanks at a safe level.
When the valve failed, an air fan damper closed, overheating
the gas combustion unit, which caused the hydrogen flame inside
the unit to flare up through a vent on the ship's deck.
The unit did not have equipment to detect the closing of the
air damper and had ineffective flame scanners, so the combustion
unit's alarm and shut-down mechanisms did not activate in time
to stop the flame flaring through the vent.
"This incident highlights the importance of ensuring
automated shipboard operating systems are equipped with safety
controls to prevent hazardous consequences in the event of a
malfunction," the agency said.
The German firm that built the gas combustion unit, Saacke,
has since installed new equipment on the unit's air fan
discharge dampers and has programmed the unit to shut down if a
fault is detected, the bureau said.
(Reporting by Sonali Paul in Melbourne; Additional reporting by
Yuka Obayashi in Tokyo; Editing by Christian Schmollinger)
((Sonali.Paul@thomsonreuters.com; +61 407 119 523;))